Fanuc | Wn57 Override Function Is Active [verified]

After setting all overrides to 100%, press the RESET button to clear the message.

on FANUC CNC controls indicates that the machine is running with an active feed override or rapid override function tied to a safety or watchdog feature that modulates axis motion. It’s commonly seen as a displayed override status (often in the MPG/MDI or alarm/message area) when the control has detected a condition where commanded motion has been limited or overridden by the system. The exact behavior and causes vary by FANUC series and machine OEM implementation. fanuc wn57 override function is active

: Since WN (Warning) alarms are often informational, the machine might still run, but specific safety or logic interlocks handled by the PMC could be bypassed by the active override. 【报警】FANUC PMC"WN57 OVERRIDE FUNCTION IS ACTIVE" After setting all overrides to 100%, press the

If the machine has finished being serviced or debugged, you should disable this function to return to standard operation. Use one of the following methods: Via PMC Parameters: Navigate to the PMC Parameter setting screen. Locate the Override Function (often listed as "倍率功能" or "Override Mode"). Move the cursor to the "Valid" setting and change it to Via Keep Relays (K-Address): Change the value of system keep relay Why This Message Appears Active Debugging: The exact behavior and causes vary by FANUC